Removal of geosynthetics

The removal spreader bar is a hydraulically driven excavator attachment that pulls installed geosynthetics out from beneath the base course, separates the aggregate cleanly and winds the geosynthetic onto a core under controlled tension. It is engineered for low-waste, mechanised deconstruction of site roads, working platforms and storage areas.

The spreader bar is qualified for Naue Secugrid^®, Combigrid^® and Secutex^® and works with comparable polymer geosynthetics from other manufacturers. Project-specific suitability is confirmed with the Naue application engineering team.

In many cases yes. Clean separation during the lift means the aggregate is available for direct reuse on the next site road, working platform or sub-base — without remediation or screening in most cases.

In many cases yes — particularly on temporary structures with light to moderate loading and no contamination. Naue assesses each consignment and routes it to direct reuse or to single-stream recycling.

Mono-material polyolefin (PE, PP) and polyester (PET) geosynthetics are recyclable as single streams. Naue coordinates the onward route to the recycling partner.

The spreader bar is designed for standard tracked excavators in the typical earthmoving size range. Project-specific carrier confirmation is provided as part of the planning phase.

Cycle times are predictable and faster than manual removal. Typical site rates are confirmed by the application engineering team based on panel size, aggregate type and excavator carrier.